Operator stop messages for Enigma and Shotmaster (S-XXX)

Operator stop messages for Enigma and Shotmaster (S-XXX)

	Note
	If the message persists, please contact your service organization.

Number	Infos messages	Explanations / Remedies
S-000	Initialize, please wait...	Wait until the initialization has finished.
S-001	Coffee boiler is heating...	Wait until the coffee boilers has reached their nominal temperature (both coffee boilers are heating after an initialization and if machine has been switched on from main isolator switch, once the cold flush has completed).
S-002	Bean hopper rear missing	Check if the rear bean hopper is inserted correctly.
S-003	Bean hopper front missing	Check if the front bean hopper is inserted correctly.
S-004	Please empty the grounds drawer.	The grounds drawer must be emptied before the cleaning can be started.
S-005	Risk of injury! Please empty the grounds drawer carefully. The grounds drawer was filled with hot water during cleaning.	During the cleaning, the grounds drawer is being filled with water.
S-006	Grounds drawer is full.	The grounds drawer has to be emptied.
S-007	Please insert the grounds drawer.	The grounds drawer out time elapsed → When the grounds drawer is inserted now, a message box appears asking if the grounds drawer has been emptied (YES or NO).
S-008	Please insert the grounds drawer.	The coffee machine can only continue if the grounds drawer is inserted.
S-009	Grounds drawer missing.	The sensor has detected that the grounds drawer is missing.
S-010	Bean hopper front is empty or locked. Please refill or unlock the bean hopper.	The brewing module has detected no coffee powder in the chamber. The bean hopper front has to be refilled or unlocked.
S-011	Bean hopper rear is empty or locked. Please refill or unlock the bean hopper.	The brewing module has detected no coffee powder in the chamber. The bean hopper rear has to be refilled or unlocked.
S-012	Bean hopper is empty or locked. Please refill or unlock the bean hopper.	The brewing module has detected no coffee powder in the chamber. The bean hopper has to be refilled or unlocked.
S-013	Coffee quantity too high (last product on the left side).	→ Check if a powder chute product was the problem (too much powder inserted).
S-014	Rinse necessary. The coffee boiler isn't allowed to heat before the machine is rinsed.	Press the rinse key in the upper right corner.
S-015	Check cleaning ball dispenser. Blocked or broken cleaning balls? Light barrier dirty?	The machine has been cleaned 10x without a cleaning ball! → Check if a cleaning ball is blocked or broken. The coffee machine is blocked now until the next cleaning with cleaning balls!
S-016	The coffee machine has been cleaned without cleaning balls. Coffee cleaning ball dispenser empty? Blocked or broken coffee cleaning balls?	Check if the cleaning ball dispenser is empty. If yes, refill it. Maybe new cleaning balls have to be ordered. → Check if a cleaning ball is blocked or broken. The coffee machine is blocked now until the next cleaning with cleaning balls!
S-017	Cleaning necessary. Please start the cleaning process.	No coffee products can be produced until a cleaning is performed. → Press and hold the rinse key for three seconds to start the cleaning.
S-018	The last cleaning hasn't been finished correctly. Please start the cleaning process again.	The cleaning cycle has been interrupted. → Check if the operator has removed the bean hopper during the cleaning process → A new cleaning has to be started again.
S-020	Brewing unit failure. The brewing unit is blocked. => Please check the brewing unit.	This warning is set, if the brew unit is blocked. E.g. if both sides are blocked or the brew chamber of one side blocks the other side.
S-021	Grounds bin is full. Please empty the grounds bin and press Continue.	Empty the grounds bin and press the button.
S-022	Coffee quantity too high (last product on the right side).	→ Check if a powder chute product was the problem (too much powder inserted).
S-023	Cleaning required. Please wait until all boilers are ready.	No action necessary.
S-024	Clean the milk tubes with a damp cloth. Remove and clean the milk cleaning container.	Clean the milk tubes with a damp cloth. → Remove and clean the milk cleaning container.
S-025	Grounds drawer is full. Please wait until the running product has finished... Empty the grounds drawer as soon as the running product has finished.	Grounds drawer is full. Please wait until the running product has finished.
S-026	Remove the milk tank. Fill the empty cleaning tank with 25ml Everclean (press pump once) Place milk tubes inside cleaning container. Place the container in the fridge.	Remove the milk tank. Fill the empty cleaning tank with: E'4ms: 50ml Everclean (press pump twice) E'2ms: 25ml Everclean (press pump once) Press Continue.
S-027	Interface not detected. All products are locked. Please check the interface connection and setting.	This message only occurs if you use an external interface (CSI or CCI).
S-028	The milk system has been cleaned without detergent. The coffee machine is blocked now until the next cleaning with Everclean!	The coffee machine is blocked now until the next cleaning with detergent!
S-029	Milk fridge door open. Please close the fridge door properly.	This message is only set if surveillance of milk fridge door is activated. → Check if the fridge door is correctly closed.
S-030	Source water tank empty. Please refill source water tank.	Reed switch has detected that the source water tank is empty. → Refill the source water tank.
S-031	Waste water tank full. Please empty waste water tank.	Reed switch has detected that the waste water tank is full. → Empty the waste water tank.
S-032	Milk unit not connected. Water pump has been switched off.	-
S-033	Display open. Please close the display properly.	Check if display is closed properly.
S-034	Bean hopper rear is empty or locked. Please refill or unlock the bean hopper.	The brewing module has detected no coffee powder in the chamber. The bean hopper rear has to be refilled or unlocked.
S-035	Bean hopper front is empty or locked. Please refill or unlock the bean hopper.	The brewing module has detected no coffee powder in the chamber. The bean hopper front has to be refilled or unlocked.
S-036	Have you refilled the source water tank?	Have you refilled the source water tank?
S-037	Have you emptied the waste water tank?	Have you emptied the waste water tank?
S-038	Please empty waste water tank.	Please empty waste water tank.
S-039	Please replace the grounds drawer with the red one.	Please replace grounds drawer before cleaning.
S-040	Risk of injury! Please empty the red grounds drawer carefully. The grounds drawer was filled with hot water during cleaning. Replace the red grounds drawer with the normal one.	Please replace grounds drawer after cleaning.
S-041	Open powder unit and remove the mixer with pipe (A, B, C). Remove the chutes (D). Clean all parts under tap water and dry them. Put back the chutes, the pipe and the mixer (D, C, B, A) Close the powder unit.	Open powder unit and remove mixer. Clean and dry the mixer. Put the mixer back and close powder unit.
S-042	-	Take cleaning container. Put two cleaning tablets inside. Place container under left coffee outlet.
S-045	Drip tray is missing.	-
S-046	Don't remove the milk tubes from milk container! The milk in the tube will be pushed back.	-
S-100	Steam boiler is heating...	This message occurs if the steam boiler pressure is below 0.8 bar and the boiler starts to heat to the nominal value (e.g. in the morning after switching on the coffee machine).
S-101	Please switch off the machine.	This message occurs if the steam boiler has been emptied or depressurized. → The coffee machine has to be switched off (main switch).
S-102	Empty steam boiler...	This message is displayed during the process of emptying the steam boiler. → Wait until the boiler is emptied or abort by pressing the stop button (upper left corner).
S-103	Depressurize steam boiler...	This message is displayed during the process of depressurizing the steam boiler. Wait until the boiler is depressurized or abort by pressing the stop button (upper left corner).
S-104	Fill steam boiler...	If the water level is lower than the security level the steam boiler has to be filled. → Wait until the steam boiler is filled.
S-105	Rinse necessary. The steam boiler isn't allowed to heat before the machine is rinsed.	After switching on the coffee machine, the steam boiler has to wait until the rinse button is pressed before it is allowed to heat. → Press the rinse button in the upper right corner.
S-106	Initialize, please wait...	Just wait until the coffee machine is initialized.
S-107	Steam boiler security probe problem.	This alarm is displayed if the circuit of the security probe is open (i.e. wire disconnected). All steam and hot water products will be deactivated and power to heating element will be switched off.
S-109	Display open. Please close the display properly.	Check if display is closed properly.

visibility-public, visibility-restricted-us, category-enigma, filter-machines-enigma, visibility-restricted, category-shotmaster-in-box, topic-operating, filter-machines-shotmaster-in-box

Popular posts

Dispense a hot water product

Brand Ambassadors Images

Topic fully translated (no picture)